Automate and protect your water-pumping system with the Marquis EC-1 Electronic Pump Controller. It automatically starts the pump when a tap is opened and stops it when water flow ends, helping maintain reliable water pressure without manually switching the pump on and off.

✨ Key Features

• Automatically starts and stops the water pump
• Starts the pump when water flow is detected
• Automatically stops when the tap is closed
• Built-in pressure gauge for convenient monitoring
• Dry-running protection shuts down the pump when water is unavailable
• Helps prevent frequent pump cycling
• Adjustable pump stopping delay
• LED indicators show power, pump operation and failure status
• Manual restart/reset push button
• Supports water pumps rated up to 1.1kW
• IP65-rated enclosure
• Simple inline installation
• Suitable for domestic and commercial water systems

🚰 Fully Automatic Pump Control

When a tap is opened, the controller detects the pressure or flow change and automatically starts the connected pump. After the tap is closed and water flow stops, the controller switches the pump off after the selected delay.

🛡️ Dry-Running Protection

If the water supply runs out or the pump fails to draw water, the controller detects the problem and automatically stops the pump. This helps protect the motor against damage caused by running without water.

⏱️ Adjustable Stop Delay

The stopping time can be adjusted from approximately 10 to 180 seconds. This allows the controller to accommodate different water systems while helping minimise unnecessary pump cycling.

Professional installation is recommended. Confirm that the connected pump does not exceed 1.1kW or 10A and ensure the controller is installed in the correct water-flow direction.